Issue w/ installation on Windows Ultimate 7
 

Installation stalls out and window disappears. Never asked to enter any passwords.

I have this same problem. I installed DisplayLink_iPad_v5.6_M1.exe, but the end is: "nothing" - no confirm, no settings (password etc.), no program data on HDD :(
My OS is Windows 7 Ultimate.

If you have problems installing, please post your install logs as described here. This will tell us why the install is failing.

Thanks

Wim

No Power on Display Device
 

While I can get the displaylink device to work under windows 7 very effectively, if I power off the device and disconnect the PC from it, any subsequent attempt to reconnect fails to recognise the device.

The symptoms are:
Unconnected the power light is blinking. All the software has been successfully installed and was working on a revious occasion.

If I plug the USB lead into the PC the power light goes out and there is no hardware changes detected on the PC.

The only way I have corrected this issue in the past, is to restore the system to an earlier state and go through a brand new install process.

This unfortunately has occured again.

Have followed the instructions from the previous post and the debugging tips, but cannot get the displaylink hub recognised on my system

Diagnostics files attached

Thanks for reply - here is the log http://kato.cz/share/20110531_155507.zip
Hope this helps.

No power light on when plugged into USB Normal?
 

Wim - I have Windows 7 Enterprise, I get an error message that Display Link Graphics won't work on this system. Is that true? Or is my installation problem coming from my light not coming on w/ my adapter? Many thanks.

No Power on Display Device
 

Here are the log files requested

I just registered to say I had this same issue as was able to resolve it. I uninstalled the program via control panel and re-ran the installation explicitly as an admin (right click install file > Run as Admin)

This fixed the issue for me and I had the password dialog popup at the end of the install and had the system tray icon running. The software seems to be running fine now on my iPad 2.

My OS is Win 7 Ultimate x64

Brendan

I think your problem with the install is caused by the LogMeIn driver you have. This can confuse our install.

If you uninstall LogMeIn, then install DisplayLink iPad software, then reinstall LogMeIn, it should work

Wim