Thank you for message. To your question the answer is: the system change (automatically) to basic mode. This was done when I try to install version 6.3 M1 or 7.0 M3 (on the same system as version 6.2) and system was initial in aero mode! The succession was: The system (PC) was in aero mode; I run binary file DisplayLink_7.0M3.exe; all was ok until to the end (Ready to use ...) and automatically (after 1 second) the system move to low resolution (800x600) and go to BSOD and dump memory. Is there any solution to put version 7.0 M3 or newer to my system?
|