DisplayLink Forum - View Single Post - Can't set resolution higher than 1024 x 768 with RC driver

Martin · 10-17-2009, 11:23 PM

Hi Ross,

The good news is that the edid supplied is valid and appears to come from your projector. The bad news is that it doesn't contain the 1280x720 mode that, from what I can see on the web about the projector, should be there.

These are the modes the edid says the projector can support:
-- 640 x 480 @ 60Hz IBM, VGA
-- 800 x 600 @ 56Hz VESA
-- 800 x 600 @ 60Hz
-- 1024 x 768 @ 60Hz VESA

I suggest you wiggle the vga cable a bit, and in the meantime, I'll ask around to see if there is anything else that can be done.

10-17-2009, 11:23 PM	#4
Martin Member Join Date: Sep 2009 Posts: 75	Hi Ross, The good news is that the edid supplied is valid and appears to come from your projector. The bad news is that it doesn't contain the 1280x720 mode that, from what I can see on the web about the projector, should be there. These are the modes the edid says the projector can support: -- 640 x 480 @ 60Hz IBM, VGA -- 800 x 600 @ 56Hz VESA -- 800 x 600 @ 60Hz -- 1024 x 768 @ 60Hz VESA I suggest you wiggle the vga cable a bit, and in the meantime, I'll ask around to see if there is anything else that can be done.