DisplayLink Forum - View Single Post

devanl · 02-13-2011, 02:07 PM

Hello,

When I install 5.6 I do not see Direct3D support for the DisplayLink device in dxDiag. I thought I remembered something about needing to install in Safe Mode for this to work (does that still apply?) so I tried this but I get a message after agreeing to the license terms that the Administrator has restricted this installation from running in Safe Mode.

Do I need to run the install in Safe Mode to get Direct3D enabled, and if so is there a link you can provide to getting Win2k3 to allow the installer to run?

Thanks,
Devan

02-13-2011, 02:07 PM	#1
devanl Junior Member Join Date: Jan 2011 Posts: 14	Direct3D on Win2k3 Server Hello, When I install 5.6 I do not see Direct3D support for the DisplayLink device in dxDiag. I thought I remembered something about needing to install in Safe Mode for this to work (does that still apply?) so I tried this but I get a message after agreeing to the license terms that the Administrator has restricted this installation from running in Safe Mode. Do I need to run the install in Safe Mode to get Direct3D enabled, and if so is there a link you can provide to getting Win2k3 to allow the installer to run? Thanks, Devan