DisplayLink Forum - View Single Post

D43m0n · 02-28-2013, 06:50 AM

I now have another unit, not from Targus but from Kensington (sd3500v). After installing the v2 alpha 3 driver and rebooting, I connected the USB3.0 cable and waited for about 2 minutes (I read somewhere there might be a firmware update needed). After 2 minutes I disconnected and reconnected the USB3.0 cable again en there's my second DisplayLink powered screen!

Wim wrote in the release notes that ethernet doesn't work yet. That's true when you install the driver, without the DisplayLink driver my MBA recognizes an ethernet connection that fully works. Wim also wrote that audio on USB3.0 will not work, but on USB2.0 it will. All MacBooks however have a combined USB2.0 and USB3.0 port. It automatically recognizes which USB spec to use.

02-28-2013, 06:50 AM	#15
D43m0n Member Join Date: Aug 2012 Posts: 36	I now have another unit, not from Targus but from Kensington (sd3500v). After installing the v2 alpha 3 driver and rebooting, I connected the USB3.0 cable and waited for about 2 minutes (I read somewhere there might be a firmware update needed). After 2 minutes I disconnected and reconnected the USB3.0 cable again en there's my second DisplayLink powered screen! Wim wrote in the release notes that ethernet doesn't work yet. That's true when you install the driver, without the DisplayLink driver my MBA recognizes an ethernet connection that fully works. Wim also wrote that audio on USB3.0 will not work, but on USB2.0 it will. All MacBooks however have a combined USB2.0 and USB3.0 port. It automatically recognizes which USB spec to use.