[whitemoo]

Hi,

When i turn on my displaylink monitor, when i have dual monitors running off my onboard graphics card i get screen corruption on the displaylink monitor.

I am running a Dell D620, with laptop screen running and 2x24inch monitors, one on the onboard graphics card, and one running on a displaylink adapter.

But when i disconnect and reconnect either one of the monitors connected to my onboard graphics cards the corruption on the displaylink monitor goes away.

So i was thinking, is there a way to automate this process? I.e When i turn on my displaylink monitor, disconnect the onboard graphics monitors, connect the displaylink adapter monitor then reconnect the onboard graphics monitors.

Or is that what the display link driver does when i connect a displaylink device?