DisplayLink Forum - View Single Post - DisplayLink does not work on sonoma 14.4.1

sholsapple · 04-01-2024, 09:26 PM

Posted below (3/26) - I was just installing Displaylink. My issue describes not being able to get DisplayLink up and running properly after installation:

"I turned on screen reporting for DisplayLink and chose quit/reopen. However, DisplayLink still thinks the setting is off. I confirmed it is still on. I've rebooted turned the setting off/on and done a quit/reopen. I don't know why DisplayLink is not picking up the access. I'm using Sonoma 14.4.1. I'm running DisplayLink Manager 1.10.1 (Build 93)."

I submitted a support ticket, but they have been unable to help much. I created a screen recording for them but did not get an answer on where to upload it. Others at my work found that DisplayLink stopped working once they upgraded to 14.4.1.

04-01-2024, 09:26 PM	#3
sholsapple Junior Member Join Date: Mar 2024 Posts: 2	Same problem with Sonoma 14.4.2 Posted below (3/26) - I was just installing Displaylink. My issue describes not being able to get DisplayLink up and running properly after installation: "I turned on screen reporting for DisplayLink and chose quit/reopen. However, DisplayLink still thinks the setting is off. I confirmed it is still on. I've rebooted turned the setting off/on and done a quit/reopen. I don't know why DisplayLink is not picking up the access. I'm using Sonoma 14.4.1. I'm running DisplayLink Manager 1.10.1 (Build 93)." I submitted a support ticket, but they have been unable to help much. I created a screen recording for them but did not get an answer on where to upload it. Others at my work found that DisplayLink stopped working once they upgraded to 14.4.1.