DisplayLink Forum - View Single Post - Upgrading to 10.8.2 with Alpha 2 Installed

mr_kchong · 03-08-2013, 06:04 PM

Hello,

I had Alpha 2 installed and was working well until I received a prompt asking to upgrade to 10.8.2 (I believe i had 10.8.1 before the upgrade).

When it prompted for a restart, the computer was unable to boot back up again. I can only access the recovery partition.

I tried the regular, verify permission or disk repairs but it does not seem to be the case. I cannot run the typical way to run the DisplayLink uninstaller so I was wondering if any of you know a way to completely remove DisplayLink drivers through terminal or if there is a workaround to this fix.

I know that this is an issue with the displaylink drivers because it is the only difference between my computer and another. please advise.

thanks!

03-08-2013, 06:04 PM	#1
mr_kchong Junior Member Join Date: Mar 2013 Posts: 2	Upgrading to 10.8.2 with Alpha 2 Installed Hello, I had Alpha 2 installed and was working well until I received a prompt asking to upgrade to 10.8.2 (I believe i had 10.8.1 before the upgrade). When it prompted for a restart, the computer was unable to boot back up again. I can only access the recovery partition. I tried the regular, verify permission or disk repairs but it does not seem to be the case. I cannot run the typical way to run the DisplayLink uninstaller so I was wondering if any of you know a way to completely remove DisplayLink drivers through terminal or if there is a workaround to this fix. I know that this is an issue with the displaylink drivers because it is the only difference between my computer and another. please advise. thanks!