DisplayLink Forum - View Single Post - iPad Windows driver fails to install properly

Gary Miyakawa · 02-08-2012, 02:47 AM

I've tried all the steps above and not had success. I'm running W7/64 and have installed the 6.1 DisplayLink drivers. I then installed the iPad code (iPad 1) from the app store. They are both living on the same wifi network (I've pinged from W7 to the iPad)..

I never get any evidence that the ipad is trying to connect (even sniffed the inbound wifi and there was no traffic from the ipad)..

I'm sure I've missed something and am very open to suggestions.

Thanks,

Gary Miyakawa

02-08-2012, 02:47 AM	#6
Gary Miyakawa Junior Member Join Date: Feb 2012 Posts: 3	I've tried all the steps above and not had success. I'm running W7/64 and have installed the 6.1 DisplayLink drivers. I then installed the iPad code (iPad 1) from the app store. They are both living on the same wifi network (I've pinged from W7 to the iPad).. I never get any evidence that the ipad is trying to connect (even sniffed the inbound wifi and there was no traffic from the ipad).. I'm sure I've missed something and am very open to suggestions. Thanks, Gary Miyakawa