09-03-2013, 03:47 PM | #11 |
Junior Member
Join Date: Aug 2013
Posts: 13
|
Ok, USB 3 cable tested.
There is a change so far as the transmitter is now detected and flashes, but the system compatibility check still says it is not installed. Last edited by KBL; 09-03-2013 at 03:50 PM. |
09-16-2013, 06:52 PM | #12 |
Junior Member
Join Date: Aug 2013
Posts: 13
|
Ok, so as I have not been having much luck with this, I uninstalled the 7.4M software. Rebooted and then installed the 7.1M1 software and rebooted again.
Then plugged in the WPCTVPRO and now it gets detected, but as a Portable Drive!!!! Grrrrrr. |
09-21-2013, 08:42 PM | #13 |
Junior Member
Join Date: Aug 2013
Posts: 13
|
It seems we may have a solution...
From the diamond forum... "Once you get detection as a portable drive, that means that the device is ready to connect. However due to the optical nature of this device, if there is not a clear line of sight between the transmitter and receiver, then the device will not function." Will check it out as soon as I get control of the TV. lol |
09-23-2013, 10:50 AM | #14 |
Junior Member
Join Date: Aug 2013
Posts: 13
|
Finally!!!
[IMG][/IMG] It seems that after updating the drivers and then obtaining a Hi Speed USB 3.0 Cable, the only other thing I had to do was make sure that there was line of sight as suggested on the Diamond forum. All I need to do now is try to adjust the image on the receiving monitor, as it is a little larger than the one displayed on the laptop screen. Happy so far anyway. Thanks for the help. |
|
|