dingis12
07-12-2012, 08:46 PM
Hello,
I purchased 4 TrulinkŪ Wireless USB to VGA Kits, and with a few issues, all four of them installed correctly. The UI was in the system tray, and we could change settings. Then, all of a sudden, 2 of the four of them stopped working. The monitor no longer displayed, but it does show TRULink, which means that is properly connected to the monitor. The UI no longer shows up in the system tray either.
After it stopped working, I uninstalled both the DisplayLink Core Software, and the DisplayLink Graphics software. Additionally, I uninstalled the corresponding device in the Device Manager. Once I rebooted, I inserted the USB device again while making sure that the wireless VGA was connected to the monitor. The device installed fine, and I rebooted. Lastly, I installed the software on the USB device. I saw it flash the display for a second, but that was all. It appears everything is fine, but there is no UI system tray icon nor does it display on the monitor.
Additionally, I followed the directions to troubleshoot in these 3 links, and it appears that everything is functioning fine.
http://www.displaylink.org/forum/showthread.php?t=896
http://www.displaylink.com/support/ticket.php?id=327
http://www.displaylink.com/support/ticket.php?id=323
Additionally, I checked in the Event Viewer and couldn't find any indications that it was not working in there either. In Device Manager, it appears that I am getting 2 devices. I attached the pictures from both.
Also, a minor issue, and not as vital as the other, but on a third device, out of nowhere, I get the noise that the USB device was removed, the screen goes black, I get the noise again, and the screen pops up again. When it is black, all the screens on the second monitor pop back over onto the first.
Computer 1 is a Compaq dx2300 Microtower
Computer 2 is an Optiplex 755
Thank you in advance for your assistance
I purchased 4 TrulinkŪ Wireless USB to VGA Kits, and with a few issues, all four of them installed correctly. The UI was in the system tray, and we could change settings. Then, all of a sudden, 2 of the four of them stopped working. The monitor no longer displayed, but it does show TRULink, which means that is properly connected to the monitor. The UI no longer shows up in the system tray either.
After it stopped working, I uninstalled both the DisplayLink Core Software, and the DisplayLink Graphics software. Additionally, I uninstalled the corresponding device in the Device Manager. Once I rebooted, I inserted the USB device again while making sure that the wireless VGA was connected to the monitor. The device installed fine, and I rebooted. Lastly, I installed the software on the USB device. I saw it flash the display for a second, but that was all. It appears everything is fine, but there is no UI system tray icon nor does it display on the monitor.
Additionally, I followed the directions to troubleshoot in these 3 links, and it appears that everything is functioning fine.
http://www.displaylink.org/forum/showthread.php?t=896
http://www.displaylink.com/support/ticket.php?id=327
http://www.displaylink.com/support/ticket.php?id=323
Additionally, I checked in the Event Viewer and couldn't find any indications that it was not working in there either. In Device Manager, it appears that I am getting 2 devices. I attached the pictures from both.
Also, a minor issue, and not as vital as the other, but on a third device, out of nowhere, I get the noise that the USB device was removed, the screen goes black, I get the noise again, and the screen pops up again. When it is black, all the screens on the second monitor pop back over onto the first.
Computer 1 is a Compaq dx2300 Microtower
Computer 2 is an Optiplex 755
Thank you in advance for your assistance