1600x1024 Resolution Support
 

1600x1024 is a VESA standard

For what reason is it not a resolution option when setting display parameters?

1600x1024 is not a standard mode:

http://en.wikipedia.org/wiki/File:Ve...Standards2.svg

Do you mean 1600x1200? This mode is supported by DisplayLink, if reported by the monitor in the EDID AND the DisplayLink chip supports the mode (ie not a DL-12*.

Wim

VESA Standard - Yes, No, Maybe
 

You are correct - 1600 x 1024 is missing from the page to which you linked

And Silicon Graphics who sold monitors at this resolution say that 1600 x 1024 is a VESA standard and Apple's 22" Cinema Display also uses 1600 x 1024. It has certainly been supported by VESA before

Anyway, the above is besides the point :)

I have attached the EDID timing parameters file in TXT format to this message

Does this file provide all the information needed?

What has to happen for your software to support 1600 x 1024?

Best wishes
Nigel

OK - the EDID does look like it reports this mode. This mode should be supported on a DL-165 or a DL-195 chip (eg it will be advertised to support 1680x1050 or higher).

Can you post the log files, most importantly the .edid file and the DisplayLink*.log files as described here:

http://kb.displaylink.com/269

Thanks

Wim

Attached DisplayLink Support Files
 

Dear Wim

Here are the requested files

Do they help provide a solution?

Best wishes
Nigel

Thanks for the log files. There is an EDID read from the monitor and it does have 1600x1024 in it. However it is not reliably read. Our software checks the EDID periodically to check the monitor hasn't changed. If it cannot read the EDID, you will get the default mode list which will not include this mode.

Looking at the log files, I cannot see a successful read at any point, which is why you are not being offered this mode. I think this monitor is a bit unreliable when presenting its EDID.

Wim

Manual Configuration?
 

Thank you

Is there a way to get the DisplayLink driver to be manually set with the appropriate EDID information?

Or at least 1600 x 1024 @ 60Hz?

Hi

No, there is no way to force an EDID into our software. If there is no EDID, then the default common modes are offered, but this is not one of them.

Wim

Can 1600 x 1024 be added as a default common mode?

This is usually monitor-dependent. Second, Apple doesn't obey standards, this is why they're all proprietary. I've never seen 1600x1024 supported by VESA. It's either 1600x1200 or 1680x1050.

Here's a reference list for you: http://www.nobell.org/~gjm/pc/aspect.html

Like, this adapter I have works at 1366x768 on one TV over HDMI, but on another, that resolution isn't available. If your display device isn't showing that VESA standard resolution to the DisplayLink chip in the adapter, no Operation System will know.

Although, it could be the DisplayLink drivers as well :P. I saw the other posts, just giving you a reference.