Calibrating the Pen to the Screen
 

Hi. Got my Yiynova DP10 (through eBay) today, hooked it up, downloaded and installed the drivers, etc., and the device is working fine. It is the 3rd monitor (the other two being 24" LEDs). So far, so good.

It appears the Mac software doesn't provide for calibration (pen to the screen), while the PC does. Is there another way to calibrate this pen to the screen? On the left side it appears about an 1/8" off, while on the right, it's dead on (so it appears to separate as you move right to left).

In general, all apps I've tried work well, with the possible exception of Illustrator (newest version). There's a bit of a lag between strokes. I find that there is no lag at all with Illustrator CS6 (earlier version). Otherwise, for the first day, not too bad.