No love
 

I'm using Win7 RTM (64bit) with the 5.2 drivers and a UV Plus 16 from EVGA (supported in the release notes).

I went through the driver install, rebooted, and I can see three monitors in my setup. One being my laptop monitor, one being off the docking port of said laptop, and one being the UV+.

When I select 'extend desktop to this display' nothing happens. The screen is just black. I unplug the adapter from the usb and the screen flickers a second. I plug the usb back in and the screen flickers a moment (no picture) and then no display.

Any suggestions? My lappie is a HP touchsmart tx2.

I restarted the service and things came up... I'll keep everyone posted.

Black screen even though the display is correct in control Panel
 

I am having the same issue with a similar set up win 7 64bit, but I have 2 display links and only one is black right not. I upgraded my drivers and that fixed one monitor. Resetting the service made it flicker a bit and I could see a flash of the desktop but it went black again. I have had no issues with the adaptors before yesterday.

So restarting the service does nothing for me.. any suggestions?

Properly installed 5.2RC drivers to fix my blank screen issue in win 7 RC 7100
 

Once I uninstalled the old display link drivers, rebooted and then re installed the 5.2 RC drivers the issue seems to have gone away as quickly as it appeared. I guess now I just wait and hope it doesn’t happen again.