SD5900T Plug-and-Play Ports Fail Unless Using DisplayLink
 

Hello!

I’m using an SD5900T dock, and the rear plug-and-play video ports stopped working after I reduced my setup from three monitors to two.

Previously, I had two monitors connected to the plug-and-play ports and a third monitor connected via a DisplayLink port. That three-monitor configuration worked perfectly with my MacBook Air M4.

After disconnecting the third monitor (the one using DisplayLink), the remaining two monitors no longer work on the plug-and-play ports and only function when connected to the DisplayLink ports instead.

I also tested with a single monitor, and the plug-and-play ports still do not work in that configuration.

Since I’m now only using one or two monitors, I’d prefer to use the plug-and-play ports and avoid DisplayLink if possible.

Monitors: BenQ PD3200U
Computer: MacBook Air, 13-inch, M4, 2025, 32 GB
OS: Tahoe 26.2

Thank you for your help!

Hi LVaranda,

On this forum we support DisplayLink technology, therefore I recommend contacting Kensington support.

Regards,
Szymon

Will do. Thank you!!