DisplayLink Forum - View Single Post

kapstok · 04-20-2012, 04:45 PM

Thanks for your time Wim.

I uninstalled everything, even used an uninstall tool I got from Kensington support. Then I followed the steps in KB322. All went well apart from this part:

"The auto install on the dock will try to run. Let it start installing, and it should immediately exit as there is later software installed. But it will set flag to state that the auto install has run, so it should not run again."

I HAVE seen this happen a week or so ago but not this time. Result was still no ethernet, even though the rest of the docking worked fine.

So I uninstalled again. Used the onboard software, disconnected docking, updated software with the Kensington stuff and then updated that with the latest software from the Displaylink site. This time no black screens, no changing screen resolutions and ... working ethernet ! And this has been the case for 2 whole days now so fingers crossed it will keep working.

04-20-2012, 04:45 PM	#3
kapstok Junior Member Join Date: Apr 2012 Posts: 6	Thanks for your time Wim. I uninstalled everything, even used an uninstall tool I got from Kensington support. Then I followed the steps in KB322. All went well apart from this part: "The auto install on the dock will try to run. Let it start installing, and it should immediately exit as there is later software installed. But it will set flag to state that the auto install has run, so it should not run again." I HAVE seen this happen a week or so ago but not this time. Result was still no ethernet, even though the rest of the docking worked fine. So I uninstalled again. Used the onboard software, disconnected docking, updated software with the Kensington stuff and then updated that with the latest software from the Displaylink site. This time no black screens, no changing screen resolutions and ... working ethernet ! And this has been the case for 2 whole days now so fingers crossed it will keep working.