DisplayLink Forum - View Single Post - DisplayLink not working with Targus Docking Station

pipbailey · 10-20-2013, 11:49 PM

Hi James,

The registry patch did not work. I downloaded, unzipped and double clicked it. It said it applied. No change. I rebooted. No change. Unplugged and re-plugged in the Targus. No change. Leaving the USB connected, I unplugged and replugged in the Targus power. No change.

The DisplayLink just never gets launched. The monitors just sit there with their standby power blinking.

The DisplayLink has worked in the past with this configuration. For no rhyme or reason it just stops working. Then when some strange combination of powering on/off or plugging in the USB cable is performed it works. This time, I just can't figure out what that combination is. The monitors just never get detected.

10-20-2013, 11:49 PM	#2
pipbailey Junior Member Join Date: Oct 2013 Posts: 6	Still not working Hi James, The registry patch did not work. I downloaded, unzipped and double clicked it. It said it applied. No change. I rebooted. No change. Unplugged and re-plugged in the Targus. No change. Leaving the USB connected, I unplugged and replugged in the Targus power. No change. The DisplayLink just never gets launched. The monitors just sit there with their standby power blinking. The DisplayLink has worked in the past with this configuration. For no rhyme or reason it just stops working. Then when some strange combination of powering on/off or plugging in the USB cable is performed it works. This time, I just can't figure out what that combination is. The monitors just never get detected.