DisplayLink Forum - View Single Post - BSOD

Thill · 01-10-2014, 04:49 PM

Hello. Just to recap I am still awaiting commentary. but here is a recap of my situation.

I use several display link software products in my industry (USB/VGA, USB/DVI, HP Portable Monitors u160). Upon installing them into a machine, the device will install software, activate properly, registers in Device Manager, and all other debugging steps listed on this forum.

Immediately upon restarting the machine, windows will go through a boot cycle and then immediately BSOD when it calls up the dlkmd.sys driver. Referencing a string of memory addresses.

Default, plug and play installed versions are crashing as are the new 7.5 versions of the software. At a loss, situation is getting critical.

Tim

01-10-2014, 04:49 PM	#5
Thill Junior Member Join Date: Dec 2013 Posts: 7	Still Awaiting Hello. Just to recap I am still awaiting commentary. but here is a recap of my situation. I use several display link software products in my industry (USB/VGA, USB/DVI, HP Portable Monitors u160). Upon installing them into a machine, the device will install software, activate properly, registers in Device Manager, and all other debugging steps listed on this forum. Immediately upon restarting the machine, windows will go through a boot cycle and then immediately BSOD when it calls up the dlkmd.sys driver. Referencing a string of memory addresses. Default, plug and play installed versions are crashing as are the new 7.5 versions of the software. At a loss, situation is getting critical. Tim