DisplayLink Forum - View Single Post

tddk · 04-07-2014, 06:14 AM

Have used the cleaner after each uninstall.

I've run Wireshark, but I don't see any calls, and it's likely because of timing. When the PR08 is plugged in, it immediately gets Ethernet, and before I can start Wireshark on that interface, it's already off and running.

I unfortunately have not been able to experiment with disabling Internet further down the chain, to see if it would still succeed, but worth a test.

But, another update on this problem: I have a PR08 at home where it's connecting to an Eizo SX2762W via DisplayPort where I have these cursor issues.

Coming into the office today, I have another PR08 connecting to an older Eizo via DVI, and there I don't have the cursor issues with 7.5 M2.

So it's likely a DisplayPort related issue. Will try connecting via DVI to the Eizo at home later.

Also discovered another wonderful new issue: on the 7.5 M2, if Windows power saving kicks in and turns display off, the display doesn't come back up, and I have to unplug PR08 and hard shut down the laptop to recover.

Man, which I hadn't updated to 7.5.. If it ain't broken...

04-07-2014, 06:14 AM	#6
tddk Junior Member Join Date: Apr 2014 Posts: 9	Have used the cleaner after each uninstall. I've run Wireshark, but I don't see any calls, and it's likely because of timing. When the PR08 is plugged in, it immediately gets Ethernet, and before I can start Wireshark on that interface, it's already off and running. I unfortunately have not been able to experiment with disabling Internet further down the chain, to see if it would still succeed, but worth a test. But, another update on this problem: I have a PR08 at home where it's connecting to an Eizo SX2762W via DisplayPort where I have these cursor issues. Coming into the office today, I have another PR08 connecting to an older Eizo via DVI, and there I don't have the cursor issues with 7.5 M2. So it's likely a DisplayPort related issue. Will try connecting via DVI to the Eizo at home later. Also discovered another wonderful new issue: on the 7.5 M2, if Windows power saving kicks in and turns display off, the display doesn't come back up, and I have to unplug PR08 and hard shut down the laptop to recover. Man, which I hadn't updated to 7.5.. If it ain't broken...