DisplayLink Forum - View Single Post - Displaylink wont work after startup until I power cycle the device

Wim · 04-02-2015, 03:51 PM

This looks like a hardware problem and the DisplayLink chip is not being seen on the USB bus. This is the case when the logs were taken, as no DisplayLink device was seen on the USB bus. This cannot be fixed by software

Wim

04-02-2015, 03:51 PM	#2
Wim Senior Member Join Date: Feb 2009 Posts: 1,561	This looks like a hardware problem and the DisplayLink chip is not being seen on the USB bus. This is the case when the logs were taken, as no DisplayLink device was seen on the USB bus. This cannot be fixed by software Wim