DisplayLink Forum - View Single Post

Andrea Dal Maso · 10-19-2015, 02:21 PM

Hi all,
i have installed Windows 10 on my Dell Precision M3800 with Dell D3000 station.
all is working fine until i install DisplaLink 7.9 (M0 or M2 has the same behaviour).
after installing and rebooting Windows 10 goes into Automatic Repair and the only way out from the boot looping is to chosse a system restore point before the sw installation.
tried to apply all available patches, but even this has no success.
any suggestion?

10-19-2015, 02:21 PM	#1
Andrea Dal Maso Junior Member Join Date: Oct 2015 Posts: 3	problems with win10 and Dell D3000 Hi all, i have installed Windows 10 on my Dell Precision M3800 with Dell D3000 station. all is working fine until i install DisplaLink 7.9 (M0 or M2 has the same behaviour). after installing and rebooting Windows 10 goes into Automatic Repair and the only way out from the boot looping is to chosse a system restore point before the sw installation. tried to apply all available patches, but even this has no success. any suggestion?