DisplayLink Forum - View Single Post - DL-195 W7 stopped working

timk519 · 12-14-2015, 05:39 PM

I've been using a DL-195 w/a 1920x1080 monitor for a while now - then last week right before I was done with a big project the display went blank and stayed that way.

If I power-cycle the monitor, it shows the normal desktop for a few moments and then goes blank again, and stays that way.

In both circumstances the monitor doesn't go to sleep.

So far I've:

re-installed the DL software,
moved the adapter from its prior USB 2.0 connection on the computer to a 3.0 powered USB strip
Replaced the DVI cable with different one

all to no avail, so I'm looking for suggestions.

12-14-2015, 05:39 PM	#1
timk519 Junior Member Join Date: Dec 2015 Posts: 1	DL-195 W7 stopped working I've been using a DL-195 w/a 1920x1080 monitor for a while now - then last week right before I was done with a big project the display went blank and stayed that way. If I power-cycle the monitor, it shows the normal desktop for a few moments and then goes blank again, and stays that way. In both circumstances the monitor doesn't go to sleep. So far I've: re-installed the DL software, moved the adapter from its prior USB 2.0 connection on the computer to a 3.0 powered USB strip Replaced the DVI cable with different one all to no avail, so I'm looking for suggestions. Last edited by timk519; 12-14-2015 at 05:42 PM.