DisplayLink Forum - View Single Post - DisplayLinkManager 1.1.62 - ERROR: modprobe: ERROR: could not insert 'evdi': Required

Ulrick · 05-24-2016, 09:24 AM

Thanks Vanadium, it works now, and it is for sure better than nothing, but I still have some strange behaviours.

On my built in display, if I drag an application window to the right edge, it than place it in the middle and I cannot even enlarge the right side, but I have to move it and then enlarge the left side if the application window.

The external display instead, just show some resolutions, but not all of them.

But like I said,

Better than nothing!

UPDATE: after a couple of reboot, the build in display seems to work a little bit better (start blank, but reapplying changes it power on) , but the external display show always a limited amount of screen resolutions and has some glitches.

Thanks,

Ulrick

05-24-2016, 09:24 AM	#3
Ulrick Junior Member Join Date: May 2016 Posts: 3	Disabling Secure Boot Works, but there asre still some strange behaviours Thanks Vanadium, it works now, and it is for sure better than nothing, but I still have some strange behaviours. On my built in display, if I drag an application window to the right edge, it than place it in the middle and I cannot even enlarge the right side, but I have to move it and then enlarge the left side if the application window. The external display instead, just show some resolutions, but not all of them. But like I said, Better than nothing! UPDATE: after a couple of reboot, the build in display seems to work a little bit better (start blank, but reapplying changes it power on) , but the external display show always a limited amount of screen resolutions and has some glitches. Thanks, Ulrick Last edited by Ulrick; 05-24-2016 at 12:37 PM.