Thanks for the note.
After some testing
this , i got some problems with the new kernel. At the first bootup the "rainbowscreen" comes up too. The kernel 4.9.0-rc2 works _not_ fine.
I`ve builded the kernel 4.4.26 (stable) and the newest versions from the extra modules e.g. libdrm, mesa, xserver, evdev ..
After this, i activated experimental opengl (vc4) and rebooted the system - works fine.
The output from glxgears -info
Code:
Running synchronized to the vertical refresh. The framerate should be
approximately the same as the monitor refresh rate.
GL_RENDERER = Gallium 0.4 on VC4 V3D 2.1
GL_VERSION = 2.1 Mesa 13.1.0-devel (git-00baaa4)
GL_VENDOR = Broadcom
The output from lsmod:
Code:
Module Size Used by
bnep 10340 2
bluetooth 326105 5 bnep
cfg80211 427855 0
rfkill 16037 3 cfg80211,bluetooth
vc4 109413 1
evdev 11396 4
sg 18319 0
drm_kms_helper 101028 2 vc4
drm_mipi_dsi 8702 1 vc4
drm 262564 4 vc4,drm_kms_helper
syscopyarea 2945 1 drm_kms_helper
sysfillrect 3443 1 drm_kms_helper
sysimgblt 2069 1 drm_kms_helper
snd_bcm2835 20447 1
fb_sys_fops 1309 1 drm_kms_helper
snd_pcm 75762 1 snd_bcm2835
snd_timer 19288 1 snd_pcm
snd 51908 5 snd_bcm2835,snd_timer,snd_pcm
i2c_bcm2708 4834 0
bcm2835_wdt 3225 0
bcm2835_gpiomem 3040 0
uio_pdrv_genirq 3164 0
uio 8000 1 uio_pdrv_genirq
i2c_dev 5859 0
fuse 83781 3
ipv6 347530 46
My problem is, the Display HP S140u (DL 41xx) doesn't work as it should be.
I need this display as the primary (standalone) display on my RaspberryPi2 (raspian jessie).
Has anyone some experience to get the display working on an rasperrypi?