DisplayLink Forum - View Single Post

echardtb · 03-31-2025, 08:13 PM

I just got a new Macbook M3 Pro to replace my Macbook M1 Pro. I got an iVANKY hub to run three monitors and set it up with my M1 without any issues.

I have my new computer which I transferred from my old computer and when I plug in the hub, it tries to connect a display but then quickly goes back to just the Computer monitor. Evenutally if I power down the hub and power it back on, I get a message that says "USB Device is using too much power". I've disconnected all unnecssary accessories and even unplugged two of the monitos and it will not connect.

I have tried all three USB-C ports on my computer.

Anyone have the same issue? or have a potential solution I can try? Very frustrated at this point!

03-31-2025, 08:13 PM	#1
echardtb Junior Member Join Date: Mar 2025 Posts: 1	USB Device Using Too Much Power I just got a new Macbook M3 Pro to replace my Macbook M1 Pro. I got an iVANKY hub to run three monitors and set it up with my M1 without any issues. I have my new computer which I transferred from my old computer and when I plug in the hub, it tries to connect a display but then quickly goes back to just the Computer monitor. Evenutally if I power down the hub and power it back on, I get a message that says "USB Device is using too much power". I've disconnected all unnecssary accessories and even unplugged two of the monitos and it will not connect. I have tried all three USB-C ports on my computer. Anyone have the same issue? or have a potential solution I can try? Very frustrated at this point! Last edited by echardtb; 03-31-2025 at 08:20 PM.