During past 4 months been dealing with real mess since I updated from 1.10 to 1.12, ever since its been a nightmare of displays not being detected right. ... along with everyone else here on forums .. anyways ..
2 weeks ago I took a new approach for my D6000 doc (been using for 3 yrs fine till 4 months ago) .
I added 2 adapters so now connected as follows
D6000 / Displaylink port> <displaylink port to HDMI> <HDMI to D-VID> <D-VID cable to monitors> U2412M
Before I was using D6000 Displaylink port <display link cable> U2412M Displaylink port
This looks a messy as it sounds but my F-ing displays have been working again ! Pretty sure they are using the alt-display port comm now but someone who knows this better could chime in.
here is my prior thread below with the details
https://www.displaylink.org/forum/sh...ad.php?t=69603