DisplayLink Forum - View Single Post - 7.5M0 bug: breaks Miracast cloning mode and excessive drain on connected standby.

BurningOrange · 12-10-2013, 06:34 PM

Although the 7.5M0 drivers are nice and fast on my Dell Venue 8 Pro, I just discovered a couple of bugs. With the drivers installed: miracasting to a wireless display does not work in cloning (mirroring) mode. All other modes work fine. There is also an excessive power drain during connected standby. The powercfg /sleepstudy says that it is due to the Intel Graphics not shutting down properly. Once I uninstall the Displaylink driver, everything returns to normal, Miracast cloning works and connected standby has a very low power drain.

Hope you will be able to resolve this, thanks.

12-10-2013, 06:34 PM	#1
BurningOrange Junior Member Join Date: Mar 2012 Posts: 12	7.5M0 bug: breaks Miracast cloning mode and excessive drain on connected standby. Although the 7.5M0 drivers are nice and fast on my Dell Venue 8 Pro, I just discovered a couple of bugs. With the drivers installed: miracasting to a wireless display does not work in cloning (mirroring) mode. All other modes work fine. There is also an excessive power drain during connected standby. The powercfg /sleepstudy says that it is due to the Intel Graphics not shutting down properly. Once I uninstall the Displaylink driver, everything returns to normal, Miracast cloning works and connected standby has a very low power drain. Hope you will be able to resolve this, thanks.