DisplayLink Forum - View Single Post

occlumency · 12-12-2011, 12:05 PM

This did not work for me but just found it somewhere else

Unplug the adapter from the USB port.
Disconnect the DVI cable from the DisplayLink adapter.
Power off the display you normally use with the adapter.
Connect the USB cable between your computer and the DisplayLink adapter.
Wait for your displays to flash (as if a new display was connected).
The light on your DisplayLink adapter should be on now.
Connect the DVI cable to the DisplayLink adapter.
Wait a few seconds and then power on the display connected to the adapter.
If this process doesn't work, try a reboot and repeat the process once Finder finishes starting up.

http://rackerhacker.com/2011/11/17/d...-in-os-x-lion/

12-12-2011, 12:05 PM	#6
occlumency Junior Member Join Date: Dec 2011 Posts: 8	An option which didn't work for me This did not work for me but just found it somewhere else Unplug the adapter from the USB port. Disconnect the DVI cable from the DisplayLink adapter. Power off the display you normally use with the adapter. Connect the USB cable between your computer and the DisplayLink adapter. Wait for your displays to flash (as if a new display was connected). The light on your DisplayLink adapter should be on now. Connect the DVI cable to the DisplayLink adapter. Wait a few seconds and then power on the display connected to the adapter. If this process doesn't work, try a reboot and repeat the process once Finder finishes starting up. http://rackerhacker.com/2011/11/17/d...-in-os-x-lion/ Last edited by occlumency; 12-12-2011 at 01:37 PM.