DisplayLink Forum - View Single Post

Cloroxbottle · 11-08-2018, 06:07 PM

Hello,

I was hoping to get some advice as to how to set this up. I built a small intel NUC to use as a DC powered computer on a boat. Windows 10 is installed and updated, I'm running the Displaylink 9 Beta software.

Everything works fine so long as I have two monitors plugged in (HDMI and USB). Using the windows display settings I can mirror, extend , display on 1 and 2 only, and make 2 my primary display.

The problem is when I start up without the HDMI monitor connected. It seems that regardless of what I have set prior to shutdown, it automatically starts up in extended mode with the USB screen as screen 2. The end result is that any apps you run don't display anywhere but the taskbar.

I've even tried starting with an HDMI cable connected to the NUC with no monitor connected and it does the same thing.

What can I do to fix this so the USB screen will be the only one and everything displays on it?

11-08-2018, 06:07 PM	#1
Cloroxbottle Junior Member Join Date: Nov 2018 Posts: 5	AOC USB as only monitor? Hello, I was hoping to get some advice as to how to set this up. I built a small intel NUC to use as a DC powered computer on a boat. Windows 10 is installed and updated, I'm running the Displaylink 9 Beta software. Everything works fine so long as I have two monitors plugged in (HDMI and USB). Using the windows display settings I can mirror, extend , display on 1 and 2 only, and make 2 my primary display. The problem is when I start up without the HDMI monitor connected. It seems that regardless of what I have set prior to shutdown, it automatically starts up in extended mode with the USB screen as screen 2. The end result is that any apps you run don't display anywhere but the taskbar. I've even tried starting with an HDMI cable connected to the NUC with no monitor connected and it does the same thing. What can I do to fix this so the USB screen will be the only one and everything displays on it?