View Single Post
Old 07-18-2013, 06:42 PM   #1
joely
Junior Member
 
Join Date: Jul 2013
Posts: 1
Default Lenovo Carbon X1 Touch - Display disconnections/flicker

I have a Windows 8 (not 8.1) Lenovo Carbon X1 Touch with the latest video and drivers installed connecting to a Targus ACP70USZ DisplayLink device. I installed the DisplayLink software and attached the device, which worked well for a short while but ultimately started to flicker wildly and disconnect from the secondary monitor. Once the flickering starts the monitors resize, refresh and attempt to connect again. I have connected over DVI, VGA and HDMI (HDMI is my go to config). I have three monitors I have tested this with - all of which have the same issue after a period of about an hour. The experience is, let's just say - unusable. Can anyone assist with a recommendation on how to resolve this? I just updated to the 7.3 DisplayLink software and ran into the same issues. I'm about to return the device, but wanted to check first. Thanks!

Joel
joely is offline   Reply With Quote