At install() section of displaylink-installer.sh contains:
Code:
source udev-installer.sh
displaylink_bootstrap_script=$COREDIR/udev.sh
create_bootstrap_file $SYSTEMINITDAEMON $displaylink_bootstrap_script
add_udev_rule
....
print_help_message
$displaylink_bootstrap_script START
main() section of udev.sh contains only:
Code:
main()
{
action=$1
root=$2
device_id=$3
devnode=$4
if [ "$action" = "add" ]; then
create_displaylink_symlink $root $device_id $devnode
start_displaylink
elif [ "$action" = "remove" ]; then
unlink_displaylink_symlink "$root" "$device_id"
stop_displaylink "$root"
fi
}
Hence
service is not started after installation, need manual start.
Presume main() section of udev.sh need addition:
Code:
if [ "$action" = "START" ]; then
start_displaylink
fi