DisplayLink Forum - View Single Post

md53a · 12-30-2019, 06:51 PM

I am generally having good results with this Alpha version BUT, when I close the lid of my 2017 MAC running Catalina 10.15.2 (19C57), the display stays on then goes off a minute or so later and repeats this sequence. This is clearly an issue.

Also, I'm not sure that I saw it mentioned but only two of the four ports on the 13-inch 2016 and 2017 MacBook Pro with a Touch Bar support Thunderbolt 3 at full performance. (The ones on the left side.) I don't know if the reduced bandwidth matters when using multiple monitors plus gigabit ethernet + an external USB Drive; perhaps you could comment?

And finally, looking forward to being able to use my Apple Watch to authenticate instead of receiving the message that this is not supported when "sharing" screens which the DisplayLink driver must be doing.

12-30-2019, 06:51 PM	#1
md53a Junior Member Join Date: Dec 2019 Posts: 3	DisplayLink macOS App I am generally having good results with this Alpha version BUT, when I close the lid of my 2017 MAC running Catalina 10.15.2 (19C57), the display stays on then goes off a minute or so later and repeats this sequence. This is clearly an issue. Also, I'm not sure that I saw it mentioned but only two of the four ports on the 13-inch 2016 and 2017 MacBook Pro with a Touch Bar support Thunderbolt 3 at full performance. (The ones on the left side.) I don't know if the reduced bandwidth matters when using multiple monitors plus gigabit ethernet + an external USB Drive; perhaps you could comment? And finally, looking forward to being able to use my Apple Watch to authenticate instead of receiving the message that this is not supported when "sharing" screens which the DisplayLink driver must be doing.