DisplayLink Forum - View Single Post - OSX Will not Boot After Installing Drivers

vdiaz1130 · 12-12-2018, 03:50 PM

I installed the DisplayLink USB Graphics Software for Mac OS X and macOS 4.3.1 on my MB Pro 2014 Edition running Sierra 10.12.6. When prompted to restart, a log message appeared on the screen stating it was "Waiting for remote debugger connect" (see attached startupLogMsg01.jpg).

startupLogMsg01.jpg

After a few minutes of hanging on that screen, I restarted the machine while holding down "cmd+r" which allowed me to start Disk Utility. Inspecting the hard drive, the used space is exactly that of the capacity (see attached maxCapacity01.jpg and maxCapacity02.jpg).

maxCapacity01.jpg

maxCapacity02.jpg

How can I get my machine to start up again?

12-12-2018, 03:50 PM	#1
vdiaz1130 Junior Member Join Date: Dec 2018 Posts: 2	OSX Will not Boot After Installing Drivers I installed the DisplayLink USB Graphics Software for Mac OS X and macOS 4.3.1 on my MB Pro 2014 Edition running Sierra 10.12.6. When prompted to restart, a log message appeared on the screen stating it was "Waiting for remote debugger connect" (see attached startupLogMsg01.jpg). startupLogMsg01.jpg After a few minutes of hanging on that screen, I restarted the machine while holding down "cmd+r" which allowed me to start Disk Utility. Inspecting the hard drive, the used space is exactly that of the capacity (see attached maxCapacity01.jpg and maxCapacity02.jpg). maxCapacity01.jpg maxCapacity02.jpg How can I get my machine to start up again?