DisplayLink Forum - View Single Post - Advice for maximising Windows Embedded Standard 7 success

ThoricSolutions · 02-12-2019, 12:52 PM

Hi Alban,
I've not yet purchased the hardware, I wanted to learn as much as possible about the potential for success before investing, so I haven't tried any drivers yet.

The target is probably going to be a National Instrument Industrial Controller IC-3171:
http://www.ni.com/pdf/manuals/376361b.pdf

These are Intel Celeron 1.9 GHz WES7 systems, I'm told the image is very close to full Windows 7 Pro.

The device supports 2 native DisplayPort screens, I wish to add two more to make a total of four portrait mode monitors, each showing a window generated by my own software. The Portrait Mode element is important, and I'm assuming I can configure this within the Windows settings for the DisplayLink devices, and once set it will remain configured as such?

02-12-2019, 12:52 PM	#4
ThoricSolutions Junior Member Join Date: Jan 2019 Posts: 3	Hi Alban, I've not yet purchased the hardware, I wanted to learn as much as possible about the potential for success before investing, so I haven't tried any drivers yet. The target is probably going to be a National Instrument Industrial Controller IC-3171: http://www.ni.com/pdf/manuals/376361b.pdf These are Intel Celeron 1.9 GHz WES7 systems, I'm told the image is very close to full Windows 7 Pro. The device supports 2 native DisplayPort screens, I wish to add two more to make a total of four portrait mode monitors, each showing a window generated by my own software. The Portrait Mode element is important, and I'm assuming I can configure this within the Windows settings for the DisplayLink devices, and once set it will remain configured as such?