Display Link display dies after a few seconds.

barr · 12-10-2009, 01:43 PM

I'm using the lastest RC drivers with a 4 monitor setup.
Two of the monitors are on a Geforce 8800GTX, the third one on the motherboard integrated i915 and the fourth one on USB (Syncmaster U70).

Upon plugging in the U70 it starts as expected, is recognized in the Windows appearence properties but dissapears after a few seconds.
Wait a little while and a "USB device failure" notification shows up.

This scenario can be reproduced at will by unplugging/plugging the U70.
I'm running Windows 7 Ultimate, up to date.

12-10-2009, 01:43 PM	#1
barr Junior Member Join Date: Dec 2009 Posts: 1	Display Link display dies after a few seconds. I'm using the lastest RC drivers with a 4 monitor setup. Two of the monitors are on a Geforce 8800GTX, the third one on the motherboard integrated i915 and the fourth one on USB (Syncmaster U70). Upon plugging in the U70 it starts as expected, is recognized in the Windows appearence properties but dissapears after a few seconds. Wait a little while and a "USB device failure" notification shows up. This scenario can be reproduced at will by unplugging/plugging the U70. I'm running Windows 7 Ultimate, up to date.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode