How install DisplayLink Driver on Raspbian Stretch ?

lordaker · 11-13-2017, 05:37 PM

At this page, I think we have a solution:

https://www.raspberrypi.org/forums/v...p?f=66&t=12761
https://www.raspberrypi.org/forums/v...12761&start=25

Me I have two monitors (Philips Brilliance 220SW), an usb DisplayLink Certified Kensingston K33907 and a raspberry pi 3 model B V1.2 with the OS Ubuntu Mate installed. I install the last kernel 4.9.60-v7+ with the displaylink drivers for ubuntu.

But only the monitor who is connected at the adapter work. The monitor connected by HDMI display anything, just the command prompt after the raspberry have
finish to boot.

For my xorg.conf file, I used this process: https://www.novaspirit.com/2015/12/3...-raspberry-pi/

Do you know how can I do for have my two monitors work ?

And extended the display from the hdmi ouput to the usb adapter displaylink ?

Which config for my xorg.conf ?

Thank a lot...

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

11-13-2017, 05:37 PM	#4
lordaker Junior Member Join Date: Nov 2017 Posts: 5	At this page, I think we have a solution: https://www.raspberrypi.org/forums/v...p?f=66&t=12761 https://www.raspberrypi.org/forums/v...12761&start=25 Me I have two monitors (Philips Brilliance 220SW), an usb DisplayLink Certified Kensingston K33907 and a raspberry pi 3 model B V1.2 with the OS Ubuntu Mate installed. I install the last kernel 4.9.60-v7+ with the displaylink drivers for ubuntu. But only the monitor who is connected at the adapter work. The monitor connected by HDMI display anything, just the command prompt after the raspberry have finish to boot. For my xorg.conf file, I used this process: https://www.novaspirit.com/2015/12/3...-raspberry-pi/ Do you know how can I do for have my two monitors work ? And extended the display from the hdmi ouput to the usb adapter displaylink ? Which config for my xorg.conf ? Thank a lot...