Can't set resolution to native res.

[bchow]

I saw a similar thread, but I wasn't sure if this is the same issue, or just similar symptoms. I am trying to drive a monitor and not a projector. I wouldn't think that would make a difference but who am I to say

I'm using the latest 5.2 RC drivers on Windows 7 RTM x64. The max (and only resolution) I'm able to run is 1280x1024. I am trying to drive a ViewSonic VA1903wb that has a native resolution of 1440x900.

I've attached the debug zip produced by the debug tool. Is there anything I can do to run this monitor in the correct aspect ratio and resolution?

Thanks,
-Brian