WAVLINK --> monitor recognized by DL -> yet no vid output("no signal" msg onscreen)

Unkle Funk · 01-08-2022, 01:13 PM

the title says it. all. Very frustrating, because when I first hooked up the WAvLink
UG3501H, my 32 inch Dynex tv/monitor recognized right away, and I was in extended mode as I wanted. I needed to adjust resolution, as the Dynex apps were too big -----> BIG mistake.

When I switched off of 13zz X 7zz , I might have gone to a 1280xresoloution - as soon as I did that - poof - no more monitor. Now, DIsplay Link Manager recognizes the monitor now, when I plug it in, and change to correct input - it right away - gives me options to change reso, rortation etc

DisplayLink Manager 1.5.0 (Build 58.125). ---
" monitor detected". ---> but , like I said, black screen /no signal

I am running 11.6 big sur - mbp 2012 , usb 3.0 to HDMI - I have tried connection via a powered USB hub, then straight into the usb 3.0 on the computer, and again tried even running 2.0 off the back of my thunderbolt display. No luck - after that first time plugging in, its like changing the resolution F*(CKED me forever here.

Any help? Sound familiar to anybody?

Thank you in advance,
G

01-08-2022, 01:13 PM	#1
Unkle Funk Junior Member Join Date: Jan 2022 Location: LOUISVILLE KY Posts: 2	WAVLINK --> monitor recognized by DL -> yet no vid output("no signal" msg onscreen) the title says it. all. Very frustrating, because when I first hooked up the WAvLink UG3501H, my 32 inch Dynex tv/monitor recognized right away, and I was in extended mode as I wanted. I needed to adjust resolution, as the Dynex apps were too big -----> BIG mistake. When I switched off of 13zz X 7zz , I might have gone to a 1280xresoloution - as soon as I did that - poof - no more monitor. Now, DIsplay Link Manager recognizes the monitor now, when I plug it in, and change to correct input - it right away - gives me options to change reso, rortation etc DisplayLink Manager 1.5.0 (Build 58.125). --- " monitor detected". ---> but , like I said, black screen /no signal I am running 11.6 big sur - mbp 2012 , usb 3.0 to HDMI - I have tried connection via a powered USB hub, then straight into the usb 3.0 on the computer, and again tried even running 2.0 off the back of my thunderbolt display. No luck - after that first time plugging in, its like changing the resolution F*(CKED me forever here. Any help? Sound familiar to anybody? Thank you in advance, G