iPad Windows driver fails to install properly

luckycat · 12-09-2011, 03:56 PM

Wim,

You've hit the nail on the head. I did need to reboot after the installation, but here are the steps I followed:

1. Download and install iPad software v5.6 from here: http://www.displaylink.com/support/downloads_ipad.php
2. Download and install DisplayLink v6.1 from here: http://www.displaylink.com/support/downloads.php
3. Reboot
4. Connect via iPad app to laptop

*Note: I had tested without the reboot, but received the same message as noted in the OP. After the reboot, nothing but success

Thanks for the response. This would make a good sticky or tech note if you guys have those.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

12-09-2011, 03:56 PM	#5
luckycat Junior Member Join Date: Jul 2011 Posts: 4	Wim, You've hit the nail on the head. I did need to reboot after the installation, but here are the steps I followed: 1. Download and install iPad software v5.6 from here: http://www.displaylink.com/support/downloads_ipad.php 2. Download and install DisplayLink v6.1 from here: http://www.displaylink.com/support/downloads.php 3. Reboot 4. Connect via iPad app to laptop *Note: I had tested without the reboot, but received the same message as noted in the OP. After the reboot, nothing but success Thanks for the response. This would make a good sticky or tech note if you guys have those.