"No Signal" on second monitor

Wim · 01-16-2012, 03:30 PM

You need to have a primary graphics card driver installed to use DisplayLink on Windows 7, as this is used to do the 3D effects on your USB display. Currently this is shown as:

Graphics: Standard VGA Graphics Adapter ((Standard display types))
Graphics Driver: 6.1.7600.16385 Dated 2006-06-21

If you install the driver for your primary graphics card, you should be good to go!

Wim

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

01-16-2012, 03:30 PM	#2
Wim Senior Member Join Date: Feb 2009 Posts: 1,561	You need to have a primary graphics card driver installed to use DisplayLink on Windows 7, as this is used to do the 3D effects on your USB display. Currently this is shown as: Graphics: Standard VGA Graphics Adapter ((Standard display types)) Graphics Driver: 6.1.7600.16385 Dated 2006-06-21 If you install the driver for your primary graphics card, you should be good to go! Wim