Can't set resolution to native res.

HuggyBear · 11-01-2009, 09:31 AM

Hello,

I am also having this same problem since updating to 5.2. I have a display with a native of 1024x768 and only 1280x1024 is available. I have swapped monitors, VGA cables and USB cables with no joy.

Prior to the update, this monitor was working fine at native res.

The monitor connects via a VGA-DVI adapter and has never displayed anything other than 'Generic Non-PnP Monitor' so EIDID appears not to have mattered to the RC driver.

In my opinion, the ability for the user to choose their own resolution rather than trying to autodetect is far less prone to failure.

I hope this can be resolved quickly as I appreciate this technology when it works.

Thanks

-HuggyBear

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

11-01-2009, 09:31 AM	#1
HuggyBear Junior Member Join Date: Nov 2009 Posts: 1	Hello, I am also having this same problem since updating to 5.2. I have a display with a native of 1024x768 and only 1280x1024 is available. I have swapped monitors, VGA cables and USB cables with no joy. Prior to the update, this monitor was working fine at native res. The monitor connects via a VGA-DVI adapter and has never displayed anything other than 'Generic Non-PnP Monitor' so EIDID appears not to have mattered to the RC driver. In my opinion, the ability for the user to choose their own resolution rather than trying to autodetect is far less prone to failure. I hope this can be resolved quickly as I appreciate this technology when it works. Thanks -HuggyBear