Issue with DisplayLink software after rebooting

dcalliances · 03-22-2012, 10:50 PM

Hi Wim

Please find the logs that you need. There are 2 logs here - DCAUSYD080_20120323_092717_after_install.zip is a log that I gathered after the installation which is I can see 3 screen working NO PROBLEM - with the right resolution.

I also provide you - DCAUSYD080_20120323_093606_after_install_then_rebo ot.zip where this is a log where after it's working and I reboot the computer and obviously I found that it couldn't find the driver for the main display card etc and end up with small resolution.

Thanks

dcalliances · 04-01-2012, 07:20 AM

Any feedback or anything about this? I've submitted the logs everything.

Thanks

Wim · 04-03-2014, 10:41 AM

The logs show you are using v6.1 DisplayLink software? If so this is really old and you should upgrade to the latest v7.5 M2 and see if this solves the issue first.

There have been so many changes since this release it is not worth analysing the logs further.

Wim

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

04-01-2012, 07:20 AM	#2
dcalliances Junior Member Join Date: Mar 2012 Posts: 6	Any feedback or anything about this? I've submitted the logs everything. Thanks

04-03-2014, 10:41 AM	#3
Wim Senior Member Join Date: Feb 2009 Posts: 1,561	The logs show you are using v6.1 DisplayLink software? If so this is really old and you should upgrade to the latest v7.5 M2 and see if this solves the issue first. There have been so many changes since this release it is not worth analysing the logs further. Wim