USB Port replicator Display issue W8 V7.2

luiset83 · 04-25-2013, 08:12 PM

Hello, the only troubleshooting step I can think of is to remove any old/stale USB devices... You may do that with USBDeview: http://www.nirsoft.net/utils/usb_devices_view.html

Sometimes when I install a particular Windows Update or install a new DisplayLink driver, the previous USB drivers/detection logic will break because of stale/conflicting devices. When this happens, I would not be able to get any screen output, but perhaps network/audio from the hub. Try getting rid of (removing) the stale/old USB devices, especially all the ones relating to the DisplayLink hub. Next, reboot the PC. Finally, re-plug the hub. You should see USB detection happen for all the DisplayLink pieces again and hopefully your problem will be fixed.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

04-25-2013, 08:12 PM	#2
luiset83 Member Join Date: Feb 2012 Posts: 48	Hello, the only troubleshooting step I can think of is to remove any old/stale USB devices... You may do that with USBDeview: http://www.nirsoft.net/utils/usb_devices_view.html Sometimes when I install a particular Windows Update or install a new DisplayLink driver, the previous USB drivers/detection logic will break because of stale/conflicting devices. When this happens, I would not be able to get any screen output, but perhaps network/audio from the hub. Try getting rid of (removing) the stale/old USB devices, especially all the ones relating to the DisplayLink hub. Next, reboot the PC. Finally, re-plug the hub. You should see USB detection happen for all the DisplayLink pieces again and hopefully your problem will be fixed.