Running two Toshiba Dynadocks 2.0

Wim · 05-15-2013, 08:54 AM

Hi

I think these were the first dynadocks Toshiba released. When manufacturing them, they managed to program them all with the same serial number - all zeros. This means multiple devices cannot be distinguished on the USB bus, so our software can only communicate with one dock at a time.

Unfortunately this is a limitation and means only one of this first generation dynadock can be used at a time. Toshiba fixed this in their later dynadocks that are sold now.

And no - there is no way for a user to reprogram the serial number. It has to be done in the factory.

Wim

swimmer · 05-15-2013, 09:14 AM

Thanks for the quick response. Unfortunately it's not the answer I was hoping for. Thank you very much anyway. I'll stop going crazy ...

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

05-15-2013, 08:54 AM	#1
Wim Senior Member Join Date: Feb 2009 Posts: 1,561	Hi I think these were the first dynadocks Toshiba released. When manufacturing them, they managed to program them all with the same serial number - all zeros. This means multiple devices cannot be distinguished on the USB bus, so our software can only communicate with one dock at a time. Unfortunately this is a limitation and means only one of this first generation dynadock can be used at a time. Toshiba fixed this in their later dynadocks that are sold now. And no - there is no way for a user to reprogram the serial number. It has to be done in the factory. Wim

05-15-2013, 09:14 AM	#2
swimmer Junior Member Join Date: May 2013 Posts: 2	Thanks for the quick response. Unfortunately it's not the answer I was hoping for. Thank you very much anyway. I'll stop going crazy ...