Renesas Update

KBL · 09-16-2013, 06:52 PM

Ok, so as I have not been having much luck with this, I uninstalled the 7.4M software. Rebooted and then installed the 7.1M1 software and rebooted again.
Then plugged in the WPCTVPRO and now it gets detected, but as a Portable Drive!!!!

Grrrrrr.

KBL · 09-21-2013, 08:42 PM

It seems we may have a solution...

From the diamond forum...

"Once you get detection as a portable drive, that means that the device is ready to connect. However due to the optical nature of this device, if there is not a clear line of sight between the transmitter and receiver, then the device will not function."

Will check it out as soon as I get control of the TV. lol

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

09-16-2013, 06:52 PM	#1
KBL Junior Member Join Date: Aug 2013 Posts: 13	Ok, so as I have not been having much luck with this, I uninstalled the 7.4M software. Rebooted and then installed the 7.1M1 software and rebooted again. Then plugged in the WPCTVPRO and now it gets detected, but as a Portable Drive!!!! Grrrrrr.

09-21-2013, 08:42 PM	#2
KBL Junior Member Join Date: Aug 2013 Posts: 13	It seems we may have a solution... From the diamond forum... "Once you get detection as a portable drive, that means that the device is ready to connect. However due to the optical nature of this device, if there is not a clear line of sight between the transmitter and receiver, then the device will not function." Will check it out as soon as I get control of the TV. lol