Multiple Docks forgetting Clone displaly settings

Wim · 10-22-2013, 10:18 AM

It doesn't forget the setting. The default behaviour when it sees a new display ID is to extend the display rather than clone. It should be easy to set up clone by using the Windows Key + P.

Once the display has been set to clone for that projector, Windows should remember the setting the next time it connects to that projector.

Wim

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

10-22-2013, 10:18 AM	#2
Wim Senior Member Join Date: Feb 2009 Posts: 1,561	It doesn't forget the setting. The default behaviour when it sees a new display ID is to extend the display rather than clone. It should be easy to set up clone by using the Windows Key + P. Once the display has been set to clone for that projector, Windows should remember the setting the next time it connects to that projector. Wim