Toshiba Dynadock U3.0 main input USB cable issue

Dan · 03-18-2015, 08:48 PM

Our products work with compliant cables.

The DisplayLink chip is behind a hub chip, and that is responsible for any behaviour you are seeing. The Dynadock uses good components, so it sounds like you have a bad cable.

If there is a reliable USB 2.0 (HS) connection, then we should operate without any issue, although you will see reduced performance (HS peaks at 320Mbps of the 480MHz signalling rate).

USB 3.0 is very sensitive to cable quality, and if you are unlucky, rather than falling back to USB 2.0, it could fail to operate at all.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

03-18-2015, 08:48 PM	#2
Dan Banned Join Date: Nov 2009 Posts: 104	Our products work with compliant cables. The DisplayLink chip is behind a hub chip, and that is responsible for any behaviour you are seeing. The Dynadock uses good components, so it sounds like you have a bad cable. If there is a reliable USB 2.0 (HS) connection, then we should operate without any issue, although you will see reduced performance (HS peaks at 320Mbps of the 480MHz signalling rate). USB 3.0 is very sensitive to cable quality, and if you are unlucky, rather than falling back to USB 2.0, it could fail to operate at all.