Gentoo ebuilds

gaya · 10-20-2015, 01:30 PM

It works pretty nice. In my setup I can use the 2 TVs connected via the two HDMI ports. DP is not tested by me.
However, to install the ports I had to change the ebuild RDEPEND:
/var/lib/layman/maggu2810-overlay/x11-drivers/displaylink-driver/displaylink-driver-1.0.138-r1.ebuild

RDEPEND="virtual/libusb:1
x11-video/evdi"

->
RDEPEND="virtual/libusb:1
x11-drivers/evdi"

because there is no x11-video
Then I could add the "displaylink" service with systemctl and add the evdi module to evid.conf in the /etc/modules-load/evdi.conf ("evdi").

Thank you!

maggu2810 · 11-10-2015, 07:54 PM

Thank you.
I fixed that, perhaps you could write me a E-Mail next time, so I does not loose your hint.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

10-20-2015, 01:30 PM	#1
gaya Junior Member Join Date: Jul 2015 Posts: 3	It works pretty nice. In my setup I can use the 2 TVs connected via the two HDMI ports. DP is not tested by me. However, to install the ports I had to change the ebuild RDEPEND: /var/lib/layman/maggu2810-overlay/x11-drivers/displaylink-driver/displaylink-driver-1.0.138-r1.ebuild RDEPEND="virtual/libusb:1 x11-video/evdi" -> RDEPEND="virtual/libusb:1 x11-drivers/evdi" because there is no x11-video Then I could add the "displaylink" service with systemctl and add the evdi module to evid.conf in the /etc/modules-load/evdi.conf ("evdi"). Thank you!

11-10-2015, 07:54 PM	#2
maggu2810 Junior Member Join Date: Sep 2015 Posts: 7	Thank you. I fixed that, perhaps you could write me a E-Mail next time, so I does not loose your hint.