Displaylink & Catalyst Control Center

tallman · 10-28-2015, 09:14 PM

Update - I downloaded and installed the latest e1659Fwu driver from AOC, ran the install, rebooted, then plugged in the AOC 31659Fwu monitor. The AOC logo showed on the 1659 screen then the monitor went black and stayed that way. I was able to see the "7th monitor" in the Windows "screen resolution" utility and in Catalyst Control Center. "Extend my display" was applied in both places but the monitor remained "inactive". I see some posts where updating the USB 3.0 driver is recommended - maybe I will give that a try. Still looking for helpful suggestions. Tallman

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

10-28-2015, 09:14 PM	#2
tallman Junior Member Join Date: Oct 2015 Posts: 4	Update - I downloaded and installed the latest e1659Fwu driver from AOC, ran the install, rebooted, then plugged in the AOC 31659Fwu monitor. The AOC logo showed on the 1659 screen then the monitor went black and stayed that way. I was able to see the "7th monitor" in the Windows "screen resolution" utility and in Catalyst Control Center. "Extend my display" was applied in both places but the monitor remained "inactive". I see some posts where updating the USB 3.0 driver is recommended - maybe I will give that a try. Still looking for helpful suggestions. Tallman