Display HP S410u possible workling with RaspberryPi

[Mahdi2016]

Hi Michal,

I have built a new image, only with existing packages. I builded evdi module and evdipp without any problems.
The system is an up-to-date Raspian Jessi.

After testing the following commands, there was always the error message: *No usable EVDI found* (The evdi module under lsmod is active.)

Here is the output from 'example' command of the terminal window is at follows:

#as root:
Starting program: /bin/example /home/pi/EDIDv1_1440x900
[Thread debugging using libthread_db enabled]
Using host libthread_db library "/lib/arm-linux-gnueabihf/libthread_db.so.1".
[libevdi] ioctl: drop_master error=-1
Attempting to use device /dev/dri/card1...
[libevdi] ioctl: drop_master error=-1
Press Enter or Ctrl+C to quit...

#as user:
Starting program: /bin/example /home/pi/EDIDv1_1440x900
[Thread debugging using libthread_db enabled]
Using host libthread_db library "/lib/arm-linux-gnueabihf/libthread_db.so.1".
No usable EVDI found
[Inferior 1 (process 3898) exited with code 02]

No Screen showed up.

And the output from 'monitorsim' command of the terminal window is at follows:

#as root:
Starting program: /bin/monitorsim /home/pi/EDIDv1_1440x900
[Thread debugging using libthread_db enabled]
Using host libthread_db library "/lib/arm-linux-gnueabihf/libthread_db.so.1".
[libevdi] ioctl: drop_master error=-1
[libevdi] ioctl: drop_master error=-1
[libevdi] ioctl: drop_master error=-1
[libevdi] ioctl: drop_master error=-1
No protocol specified
QXcbConnection: Could not connect to display :0

Program received signal SIGABRT, Aborted.
0x75f89f70 in __GI_raise (sig=sig@entry=6) at ../nptl/sysdeps/unix/sysv/linux/raise.c:56
56      ../nptl/sysdeps/unix/sysv/linux/raise.c: No such file or directory.

#as user:
Starting program: /bin/monitorsim /home/pi/EDIDv1_1440x900
[Thread debugging using libthread_db enabled]
Using host libthread_db library "/lib/arm-linux-gnueabihf/libthread_db.so.1".
No usable EVDI found
[Inferior 1 (process 3864) exited with code 02]

The output from the "xrandr" is the same as in my last post.

I hope this information will help you.

Best regards
Michael